Kategorier

Produsenter

M0CVO - HW-80HP Se i full størrelse

M0CVO - HW-80HP

40,56 meter lang dipol antenne med offsett.

Mer detaljer

Tilgjenglig: For øyeblikket utsolgt

869,00 kr

Legg til kurv

Den M0CVO HW-40HP.
Dette er en av-senter matet dipol som omfatter M0CVO 4:1 balun slik at den kan mates direkte med 50ohm koaksialkabel.

HW-40HP er bare 20.28m i lengde, og vil operere på 40, 20 og 10m uten ATU og 80, 60, 15, 6 og WARC Bands med en ATU.
VSWR er bedre enn 1,5:1 på resonansbånd (40, 20 og 10 m)

 

M0CVO HW-80HP 

The HW-80HP is an Off Centre Fed Dipole designed to operate on 80m (3.5MHz), 40m (7MHz), 20m (14MHz) and 10m (28MHz) without an ATU and 60m(5MHz), 15m(21MHz) and WARC Bands with an ATU. Having a feedpoint at 1/3 of the way along instead of halfway along gives a feedpoint impedance of 200 Ω . This is not ideal for modern day transceivers requiring an antenna with a 50 Ω impedance. Therefore, a 4:1 current balun is added at the feedpoint to alter the impedance to something closer to the 50Ω required. This then allows the antenna to be fed using standard 50Ω coaxial cable such as RG8 or RG213. 

 

The overall length of the antenna is 40.56m or 132ft. It may be mounted horizontally, as a sloper, or as an inverted vee. If space is at a premium it may also be ‘bent’ to fit in with little or no loss in performance. Best performance will be seen when mounted at least one quarter wave above the ground at the lowest frequency . It may be mounted lower if necessary but due to the varying nature of the ground below, the overall impedance and performance may be affected slightly. 

Due to the length of this antenna and weight of the wire elements it is advisable to use the balun housing as a support for the antenna as well as the end insulators on the legs. However, as this is not always practicable sturdy strain relief rings are included here. 

To reduce feedline losses it is advisable to use a quality coaxial cable such as RG213 or RG-8. RG58 cable is thin and lightweight and overall very lossy. 

 

Please note, a good ATU will be required for optimum performance.